Mondo Macchina Nr. 1-2 - Anno 2023

n. 1-2/2023 65 TECHNOLOGY tata una testata abbattitrice-allestitrice. La testata taglia alla base l’albero da abbattere, ne indirizza la direzione di caduta, provvede contesualmente alla sramatura e, se necessario, all’accatastamento del materiale così allestito. La testata comprende: una pinza di presa che trattiene il tronco consentendone l’abbattimento e la movimentazione controllata; una sega a catena azionata da un motore idraulico, per il taglio (in alcuni casi la sega a catena può essere sostituita da una sega a disco o da un meccanismo a cesoia); una serie di dispositivi (solitamente due o più rulli azionati idraulicamente) che spingono il tronco contro appositi coltelli per consentire la sramatura dell’albero. Con la medesima sega a catena si provvede poi a sezionare il tronco secondo misure predefinite. Una volta accatastato, il legname può essere esboscato mediante trattori e rimorchi forestali, skidder e forwarder. L’unità motrice può essere dotata di ruote o cingoli. Nel primo caso, esistono in commercio harvester a 4, 6 e 8 ruote motrici. Ovviamente, all’aumentare del numero di assi motori, aumenta la stabilità e la portanza della macchina, a discapito però della sua maneggevolezza e agilità in bosco. La versione cingolata, al contrario, può prevedere sui tradizionali due assi o un unico cingolo per lato, o un cingolo trapezoidale per mozzo, in modo da realizzare un’unità motrice a 4 cingoli indipendenti e autolivellanti. In tal modo è possibile operare in sicurezza anche in zone ad elevata pendenza (fino al 60%) non raggiungibili con i modelli gommati (< 30%). Dal punto di vista costruttivo, un harvester è caratterizzato da un motore di potenHarvesters. The harvester, or felling machine, is a machine consisting of a drive unit and a hydraulically driven arm with a felling head mounted on the end. The harvester head cuts the tree to be felled at the base, directs its direction of fall, and at the same time removes the limbs and, if necessary, stacks the material thus prepared. The header includes: a gripper that holds the log, allowing it to be felled and moved in a controlled manner; a chainsaw driven by a hydraulic motor, for cutting (in some cases the chainsaw can be replaced by a disk saw or a shear mechanism); a series of devices (usually two or more hydraulically driven rollers) that push the log against special blades to allow the tree to be cut. The same chainsaw is then used to section the log according to predefined measurements. Once the timber has been stacked, it can be harvested using forestry tractors and trailers, skidders and forwarders. The drive unit can be equipped with wheels or tracks. In the former case, there are 4-, 6- and 8-wheel drive harvesters on the market. Obviously, as the number of driving axles increases, the stability and lift of the machine increases, at the expense, however, of its manoeuvrability and agility in the forest. The tracked version, on the other hand, can have either a single track on each side of the traditional two axles, or a trapezoidal track on each hub, to create a drive unit with four independent, self-levelling tracks. This makes it possible to operate safely even on steep slopes (up to 60%) that cannot be reached with wheeled models (< 30%). From a construction point of view, a harvester fea-

RkJQdWJsaXNoZXIy NTY4ODI=