Mondo Macchina - Nr. 10-11 - Supplemento Componentistica - Anno 2026

n. 10-11/2026 37 TECHNOLOGY C’è catena e catena. Proprio questa distinzione crea, per così dire, due categorie di catene da neve. Le prime sono quelle per uso saltuario, ossia per un impiego in tutto simile a quello fatto per mezzi pesanti o autovetture: si montano in caso di necessità e si smontano subito dopo. Uno dei primi requisiti, per questa categoria, è il costo contenuto, dal momento che potrebbero non essere utilizzate nemmeno una volta nel corso dell’anno. Per questo motivo ci sono sul mercato catene in tutto simili a quelle per mezzi pesanti, ma con dimensioni adatte alle ruote di un trattore, che ormai superano i 2 metri di diametro. Sono dispositivi a maglia singola o doppia, realizzati da vergelle (bobine di filo d’acciaio) aventi un diametro di 6 mm o poco superiore, in quanto non devono sopportare un impiego continuativo nel tempo. Discorso diverso per le catene che potremmo definire professionali, ossia destinate ad essere applicate ai mezzi spazzaneve, che siano trattori, pale o telescopici. In questo caso, e soprattutto nelle zone montuose, le catene sono spesso installate a inizio stagione e lasciate in posizione fino alla fine dell’inverno. Se non altro, perché montare una catena che pesa 100 o più kg non è così agevole. Pertanto, è evidente che sono sottoposte a stress molto superiori rispetto a una catena utilizzata per qualche ora durante la brutta stagione. «Un trattore con lama da neve può percorrere centinaia di chilometri con le catene sulle ruote. Per sopportare tali sollecitazioni è indispensabile utilizzare tecniche speciali e diametri del filo importanti», spiega Andrea Anghileri, manager di Konig. Per questo motivo, le catene di tipo professionale sono realizzate con maglie più fitte e un filo d’acchains are a must, for safety even without the Traffic Code. They are particularly important for all those vehicles that carry out so-called winter services (snow + salt, for example), but it is important to clarify that even a normal tractor performing transport or transfer operations on precarious asphalt conditions should be equipped with them. There are chains and there are chains. This very distinction creates, so to speak, two different categories of snow chains. The first are those for occasional use, that is, for a use completely similar to that for heavy vehicles or cars: they are mounted when necessary and disassembled immediately afterwards. One of the first requisites for this category is low cost, since they may not be used even once during the year. For this reason, there are chains on the market that are very similar to those for heavy vehicles, but with dimensions suitable for tractor wheels, which now exceed 2 meters in diameter. These are single or double mesh devices, made from wire rods (coils of steel wire) with a diameter of 6 mm or slightly more, as they do not have to withstand continuous use over time. The situation is different for chains that we might define as professional, that is, intended for application on snowplows, be they tractors, shovels or telescopic handlers. In this case, and especially in mountainous areas, the chains are often installed at the beginning of the season and left in place until the end of winter. If for no other reason than because fitting a chain that weighs 100 kg or more is not very easy. Thus, it is clear that they are subjected to much greater stress than a chain used for a few hours during bad weather.

RkJQdWJsaXNoZXIy NTY4ODI=