n. 10-11/2026 169 TECHNOLOGY Considerando quindi come peso aderente quello totale della motrice, le condizioni del terreno e la resistenza al rotolamento, l’aderenza sviluppabile dal mezzo nell’allestimento standard è di 19 kN. Il confronto è quindi positivo (ossia: aderenza maggiore della trazione); la lavorazione è fattibile, con un quasi totale impegno della capacità di tiro del trattore. La seconda verifica riguarda la potenza disponibile. Come visto, non tutta la potenza sviluppata dal motore è disponibile per la macchina operatrice, perché una parte viene assorbita per gli autoconsumi. A tale proposito, si possono considerare i seguenti impegni: 10% per l’autodislocamento (su terreno nudo o con pochi residui colturali); 12% per la trasmissione (power-shift semplice); 4% per l’impianto idraulico (con pompa sempre in presa e normalmente non sotto carico); 15% per lo slittamento (in aratura, la presa di potenza è ferma, e pertanto non determina alcun assorbimento). La potenza utile da dedicare alla lavorazione è quindi il 59% di quella nominale, ossia circa 47 kW. Alla velocità iniziale di 6 km/h (ovvero 1,7 m/s), la potenza richiesta al gancio è di circa 31 kW. Rispetto ai 47 kW disponibili, rimane una riserva di 16 kW che potrebbe essere proficuamente impegnata aumentando la velocità di esecuzione dell’aratura, con l’accortezza però di salvaguardare la qualità dell’intervento. Se le condizioni del terreno e la qualità dell’aratura lo consentono, la potenza utile disponibile non impegnata può essere sfruttata per aumentare la velocità di avanzamento. Mantenendo invariata, in prima approssimazione, la trazione richiesta dall’aratro, passando da 6 a 8 km/h il tempo richiesto per arare un ettaro di terreno si riduce di circa 37 miconditions and rolling resistance, the tractor in its standard configuration can develop 19 kN of traction. The comparison is therefore favorable (i.e., traction exceeds draft); the job is feasible, using almost all of the tractor’s pulling capacity. The second check concerns available power. As we have seen, internal losses absorb part of the engine power, so not all of it reaches the implement. We can assume the following shares: 10% for self-propulsion (on bare ground or with little crop residue); 12% for the transmission (simple power-shift); 4% for the hydraulic system (with the pump always engaged and normally not under load); 15% for wheel slip (during plowing, the PTO is stationary and therefore does not draw any power). The net power available for tillage is therefore 59% of the rated power, or approximately 47 kW. At an initial speed of 6 km/h (or 1.7 m/s), the required drawbar power is approximately 31 kW. Against the 47 kW available, this leaves a 16 kW reserve that could be put to good use by plowing faster, while taking care to maintain work quality. If soil conditions and plowing quality permit, you can use the available unused net power to increase the forward speed. Assuming, as a first approximation, that the plow’s draft stays constant, increasing the speed from 6 to 8 km/h reduces the time required to plow one hectare of land by approximately 37 minutes (a 25% reduction). At 9 km/h, the time savings increase to about 49 minutes (a 33% reduction).
RkJQdWJsaXNoZXIy NTY4ODI=