
Thor, the Dante's Macchine pipe layer
Thor is the new carried version pipe layer being presented at EIMA by Dante Macchine. According to the company based in Bagnoli di Sopra (Padua), this piece of equipment is capable of optimizing traditional soil drainage methods. It is being offered in two models: the Thor Open Field version and the Thor V version for Vineyards and Orchards (a more compact and smaller size model designed to move easily between the narrowest rows). The pipe layer is designed to be connected directly to the tractor, without the need for special attachments. The machine consists of a load-bearing frame with a mounted hollow anchor featuring three adjustable working positions controlled by a hydraulic piston. A large walkway allows the operator to work safely and monitor the pipe's movement during installation. At the center of the platform is a switch connected to an alarm buzzer located inside the cab designed to warn the tractor driver in the event of an anomaly or give the signal to proceed with the connection with another roll of pipe.
The roll holder support is equipped with a hydraulic piston that allows it to be lowered during loading and raised to the most suitable position for unrolling. Dante Macchine has fitted the machine with a pendulum that acts as a mechanical bubble to make it easier for the operator to position the pipe layer horizontally: when the two points are aligned, the machine is in the exact working position.
For road travel, the two reels can be moved towards the center and achieve a profile of 2.55 m. The pipe layer is equipped with Isobus technology with remote control and data transmission (4.0). The laser receiver is positioned on a telescopic numbered rod connected to a jack that facilitates its repositioning.
This transmits the impulse to the solenoid valve attached to the trolley and determines the set depth and slope.
Thor weighs 2,800 kg, can work at a laying depth of up to 1 meter with a pipe with a maximum diameter of 160 mm and requires power between 300 and 350 horsepower, dropping to 120-150 for the V version, weighing 1,730 kg and able to handle pipes with a maximum diameter of 65 mm at a maximum laying depth of 1 meter.
In addition to its pipe layer Dante is also presenting its Delta series decompactors with a working depth of up to 45 cm and an anchor consisting of four parts: central body and three tool attachments (tip with bayonet fitting, 250 mm interlocking fin and vertical knife).
The anchor pitch can vary from 55 to 70 cm. A 600 mm universal packer roller is applied to the rear, equipped with a molded part made of hardened boron steel which is resistant to impact and wear.
The Delta series consists of two models: the 400 and 500 with working widths of 4 and 5 meters, respectively. The semi-mounted Delta R version is also available. This model features a section of independently supported mixing discs behind the packer roller.
The most recent innovation from Dante Macchine is its Condor high-power spring-loaded spring cultivator without rear wheels and rollers, whose stability is provided by a section of hydraulically adjustable wavy discs. Its sturdy frame and four rows of 45 x 12 reinforced springs allow it to work at high speeds (12-14 km/h) even in difficult conditions, according to Dante Macchine.










